Skyworks Solutions, Inc.: LED Camera Flash Driver: AAT1270: AAT1270IFO-T1

Power Electronics Products from CDI

AAT1270IFO-T1
1A Step-Up Current Regulator for Flash LEDs STDFN33-14
Manufacturer: Skyworks Solutions, Inc.
Status: Standard
Data Sheet: AAT1270IFO-T1 Data Sheet
RoHS Compliance: Skyworks Solutions, Inc., AAT1270IFO-T1, LED Camera Flash Driver, 1A Step-Up Current Regulator for Flash LEDs STDFN33-14 (Rohs Compliant), Component Distributors Inc. (CDI) Yes
Specifications
Type:
Serial Boost
Flash Iout Total:
1000 mA
Movie Mode Iout Total:
137 mA
# LED Channels:
2
Vin Min:
2.7 V
Vin Max:
5.5 V
Vout Max:
5.5 V
IQ (typ):
230 µA
Interface:
S2Cwire™
Shutdown Current:
1 µA
Peak Efficiency:
85 μH
Package:
STDFN33-14
Also Available
Part FunctionPart NumberDescription
Evaluation Board AAT1270IFO-DB1 Skyworks Solutions, Inc. Demo board for AAT1270IFO-T1
The AAT1270 is a high-efficiency, high-current boost converter capable of 1A maximum output current. It is an ideal power solution for high brightness LED or LED photo flash applications in all single-cell Lithium-ion / polymer battery operated products. The AAT1270 maintains output current regulation by switching the internal high-side and low-side switch transistors. The transistor switches are pulse-width modulated at a fixed frequency of 2MHz. The high switching frequency allows the use of a small inductor and output capacitor, making the AAT1270 ideally suited for small battery-powered applications. AnalogicTech’s proprietary S²Cwire™ (Simple Serial Control™) serial digital interface is used to enable, disable and set the movie mode current level for the flash LEDs to one of 16 levels. The AAT1270 also includes a separate Flash Enable input to initiate both flash/strobe operation and the default timer, which can be used to terminate a flash event after a user programmed delay or as a safety feature. A Flash Inhibit pin is also included which reduces flash current to movie mode level during high battery demand. The maximum flash and movie mode current is set by one external resistor; the ratio between flash and movie mode current is set at approximately 7.3:1. One or two LEDs can be connected to the AAT1270; when two LEDs are used, the output current is matched between each diode. The AAT1270 contains over-voltage protection and a thermal management system to protect the device in the event of an output open-circuit and short-circuit condition respectively. Built-in circuitry prevents excessive inrush current during start-up. The shutdown feature reduces quiescent current to less than 1.0µA. The AAT1270 is available in a Pb-free, thermally-enhanced 14-pin 3x3mm STDFN package.
Pricing
QtyPrice
1 - 99 $0.723
100 - 499 $0.588
500 - 2499 $0.551
Qty 
 
Availability
Call 1-800-777-7334 for Availability or Get a Quote
Qty   
Package Format
DescriptionUnits Per FormatAvailable
(T/R) 1500 0