|
16V to 10KV: Ultra Stable, Class 1 Dielectric (EIA COG) or NPO: linear Temperature coefficient, low loss, stable electrical properties with time, voltage and frequency
|
|
X7R Dielectric is a stable EIA Class II dielectric, with +/-15% temperature coefficient and predictable variation of electrical properties with time, temperature and voltage. These chips are designed for surface mount application with nickel barrier terminations suitable for solder wave, vapor phase or reflow solder board attachment. This product is also available in silver-palladium terminations for hybrid use with conductive epoxy. Class II X7R chips are used as decoupling, by-pass, filtering
|
|
BX dielectric characteristics are identical to X7R dielectric, with the added restriction that the Temperature-Voltage Coefficient (TVC) is not to exceed -25% DC at rated voltage, over the operating temperature range (-55°C to 125°C).
|
|
RoHS Compliant, High Capacitance Value MLC capacitors in values up 100 Microfarads. This product is ideal to replace tantalum and electrolytic capacitors without polarity concerns. The low ESR characteristics allow for comparable circuit designs to be achieved at typically one-third to one-fifth of the capacitance values.
|
|
NOVACAP offers a line of low ESR surface mount capacitors ideally suited for “Tip & Ring” applications. These units are designed with 250 VDC rating to withstand the 52 VDC bias and 150 VRMS signal during ring cadence. Chips are offered in X7R dielectric from 0.39µF to 1.00µF in sizes 1812, 1825 and 2225. Product is also available in Z5U and Y5V dielectric from 0.47µF to 1.30µF for other ring detection circuits.
|
|
NOVACAP offers a line of low ESR surface mount capacitors ideally suited for “Tip & Ring” applications. These units are designed with 250 VDC rating to withstand the 52 VDC bias and 150 VRMS signal during ring cadence. Chips are offered in X7R dielectric from 0.39µF to 1.00µF in sizes 1812, 1825 and 2225. Product is also available in Z5U and Y5V dielectric from 0.47µF to 1.30µF for other ring detection circuits.
|
|
Y5V/Z5U Dielectric is a general purpose EIA Class III dielectrics with +22% to -56% (Z5U) and +22% -82% (Y5V) temperature coefficients and very high capacitance density. The NOVACAP Z5U and Y5V formulations are very stable with time, typically aging less than 2% per decade. General purpose chips are used in by-pass and decoupling functions and other applications where capacitance change over the operating temperature range is not critical.
|
|
NOVACAP offers a line of MLC chip capacitors, sizes LS 1808, LS 1812, X2, Y3 Class Compliant* specifically designed for use in modem, facsimile, telephone and other electronic equipment where lightning or overvoltage surges can occur. These parts are rated at 3,000 Vdc (Y3) and 250 Vac safety approved and certified to EN 60950. The product is compliant to Standards EN 132400: 1994/A2: 1998/IEC60384-14, Second Edition: 1993/A1:1995, and meet the requirements of EN61000-4-5, IEC1000-4-5, and IEC80
|
|
Sizes ES 2211, ES 2215 and ES2225, Y2 Class Compliant specifically designed for use in modem, facsimile, telephone and other electronic equipment where lightning or over voltage surges can occur. These parts are rated at 5000 Vdc and 250 Vac safety approved and certified to IEC60384-14
|
|
NOVACAP High Voltage Leaded Capacitors with optimum design and special testing for long term reliability are available in COG and X7R characteristics. Conformal coating and lead mounting provide a rugged configuration for optimum performance. Units may be tested to MIL-PRF-49467 and/or MIL-PRF-39014. Applications include aerospace, airborne and military use for radar, power supplies and voltage multiplier circuits. Higher than cataloged voltage ratings are available.
|
|
COG chip capacitors designed and tested to operate from -55°C to 200°C. Product applications include harsh environments such as oil exploration and automotive/avionics engine compartment circuitry. Product is available as surface mount chips in sizes 0805 to 7565.
|
|
Class II chip capacitors designed and tested to operate from -55°C to 200°C. Product applications include harsh environments such as oil exploration and automotive/avionics engine compartment circuitry. Product is available as surface mount chips in sizes 0805 to 7565
|
|
Product is available in COG(NP0) a Class I dielectric and in a Class II dielectric operating up to 200°C. Product applications include harsh environments such as oil exploration and Automotive/Avionics engine compartment circuitry. Product is available as epoxy coated devices for environmental protection with 22 AWG tinned copper leads, in sizes 1515 to 7565, marked with capacitance and voltage ratings.
|